Welder

Essential Duties and Responsibilities (Key Accountabilities)

• Must be able to understand the dimensions required for sections & Sheet piles so that he can verify the accuracy required to achieve the quality of the held product after welding & grinding.
• After rectification of the material, all the products must be segregated from prime /scrap, then stack it accordingly & strap it as per requirement.
• Keep both the Rectification Supervisor and Section Head informed about all kind of issues & problems arise during the rectification job. 
• Coordinate with other outsourced contractors & service/supplier to get the problem solved.
• Self-preparation by wearing proper PPE for welding, grinding & Gas cutting jobs which is to be performed as per the work instruction.
• Prepare proper tools & equipment’s including Fire extinguisher at the site for the work to be performed also cleared the areas around from combustible material.
• Following the instruction given by the area supervisor for the assigned jobs like Grinding, welding, Gas cutting or burning, heating, bending, hammering, stencil marking, manual binding, label replacing etc….
• Grinding the Sharp edges of the sections for clearing saw rags with care and if any defects observed on the material that need to be reported & rectified.
• Burning material & collecting samples as per instruction for re-sampling which need to be re-tested.
• If required to cut Scrap/cobble & helping in dispose off using Crane or Forklift whenever required.
• Assisting Band saw & Gag press operators in performing cut to length or crop cutting, manual stacking & bundling etc.as per requirements.
• Help the operation/maintenance team during any breakdown work if required in the Mill & Finishing area for welding, cutting, cleaning or any other work which need to be done.  

• All the jobs to be performed with utmost care observing all the safety standards for one-self & his colleague working around.
• Ensure to follow the Safe work instruction & the procedures always.
• Maintain the 5S, good housekeeping and safety culture in the yard.

Knowledge, Skills and/or Abilities (attributes) required.

To perform this job successfully, an individual must be able to perform each duty satisfactorily. The requirements listed below are representative of the knowledge, skills, and abilities required.

• Basic knowledge of Safe Grinding & welding & safe usage of the rectification tools related to work.
• Familiarization of rectification process for different defects & problems with different kind of solutions.
• Ability to understand the process & utilize it whenever required during rectification.
• Familiarize with the usage of profile cutter, Hydraulic jacks, manual Gag & Enerpac equipment using to repair the sections, sheet pile & jumbo sections.